Type exact lengths and angles

While drawing, type a length and press Enter to place the next point exactly that far. Tab sets an angle.

Place a point by length

  1. Start a run with Linear, Area or Segment, and click the first point.
  2. Point the cursor in the direction the next segment goes.
  3. Type the length, for example 12'6". It shows in the cursor label as you type.
  4. Press Enter. The point lands exactly that far along the cursor's direction.

Ortho, snapping and an angle you typed all still apply to the direction. With Circle, type the radius after clicking the center.

Backspace deletes the last character you typed. Esc clears what you typed.

Set the angle

  1. After typing a length (or before), press Tab. The label shows ∠.
  2. Type the angle in degrees, counterclockwise from pointing right (0 is right, 90 is up).
  3. Press Tab again. The direction is locked ("angle locked") and you're back to typing the length.

Press Tab with no angle typed to unlock the direction.

How to write a length

In feet and inches:

  • 12'6", 12' 6 1/2" or 12'-6 1/2": feet and inches.
  • 12-6 or 12 6: feet and inches without marks. 12 6 1/2 adds the fraction.
  • 150.5: a bare number is feet.
  • 6" or 6 1/2": inches only.

In metric, a bare number is millimeters.

You can add, subtract, multiply and divide: 12'6" + 3', **10' * 3 or (8' + 4') / 2**. A hyphen with a space on either side is a minus.

The sheet needs a scale before a typed length can be placed. If it has none, the label says "Set this sheet's scale first".

Something here doesn't match what you see in the app? Tell us at support@kredna.com.