Write an RFI
Start an RFI from the log or from a spot on the drawing, with its subject, question, sheet and spec references, a clip of the drawing, the GCs it goes to and its answer due date.
Start an RFI
- From the log: on the RFIs step, click + New RFI.
- From the drawing: in Takeoff, right-click the spot on the sheet you're asking about and pick New RFI here. The RFI starts with that sheet as its reference and a clip of the drawing around the spot.
Fill it in
On the right of the RFI log:
- Subject: a few words, such as "Partition type at corridor 2".
- Question: what you need to know, and what you'll assume if nobody answers.
- Sheet and spec reference: click + Add reference for each one. Pick the sheet, type the Spec section (such as 09 21 16 · 2.3 A) and a Detail or note (such as 5/A-501).
- The clip: an RFI made from the drawing shows its clip, which goes out in the PDF. Click Clip the drawing again to redo it, or remove it.
- To: tick All GCs on this job (including any added later), or tick the GCs it goes to. GCs are the job's recipients on the Send step; with none yet, click Add recipients in Send.
- Answer due: the day you need the answer by.
Every change is stored as you make it.
Delete a draft
A draft that was never sent can be deleted: click Delete this draft, then confirm. Undo brings it back. An RFI that was sent stays in the log.
Something here doesn't match what you see in the app? Tell us at support@kredna.com.